# Scripts to download and install gitea and act_runner binary files

Helps to install and setup the gitea and act_runner binary

## Things needed

The application "curl" and "jq" must be installed.

Both gitea and act_runner must be run a systemd control file named "gitea" and "act_runner"

## Basic setup

In `init.sh` set to the full path including the binary name:

- `target_file` as to where the gitea binary is located
- `target_file_act_runner` as to where the gitea act_runner binary is located

If the download folder should be not in the subfolder "download" change the `download_folder` variable to the path as to where the files hould be downloaded. Note that this folder must exist

## Architectures detected

Only arm64 and x86 64bit are auto detected

## Download and install: gitea

Run `download.sh` to download the latest file. Fill re-download as a different name if the same file is requested

Run `install.sh <version>` to install the newest version

## Download and install: act_runner

Run `download-act_runner.sh` to download the latest file. Fill re-download as a different name if the same file is requested

Run `install-act_runner.sh <version>` to install the newest version

## Systemd

in the `systemd` folder are systemd service files that can be used with gitea and the act_runner

Note that in the gitea.service the "[Unit]" After= block needs to be adjusted depending on what services are used

[See more here](https://docs.gitea.com/installation/linux-service)

Copy them into `/etc/systemd/system/` and run `systemctl daemon-reload`, after that they can be launched with `systemctl start <name>` and enabled with `systemctl enable <name>`